Used by electric utilities on transmission lines with the voltage of 35 kV and higher for creating optical communication lines and protecting the power lines from lightning strikes.
Applied for aerial installation on distribution and power transmission lines for building long distance optical communication systems.
Used for distributed fiber optic sensing in different applications.
Used for indoor and outdoor applications where fire resistance is a must. Remain functional under direct flame for at least 180 minutes.
Applied in ducts, conduits and trays with no risk of rodent attacks. Can also be lashed.
Designed for high reliability in harsh environments with potential mechanical impact. Applied in all ground types, swamps, and harsh rivers.
Designed for air blowing in ducts and microducts for building reliable underground communication networks.
Designed for underwater application with increased crush and tensile loads.
InAir Figure 8
Used for cost-effective one-step aerial installation mostly in rural areas where the spans between poles are not long .
Applied in substations for control purposes.
Used to create communication lines between the common distribution box and a location inside the building (including vertical runs), between entrances or corridors in office buildings.
Applied for aerial installation on transmission towers, lightning poles, between buildings and structures for communication networks in rural areas.
Designed specifically for wetland applications, such as creeks, ponds, lakes, and river crossings. Can also be used on bridge crossings or other harsh environments.
Central strength member (fiberglass reinforced plastic)
PBT loose tube filled with water-blocking gel
Aluminum and polymer tape
Armor of galvanized steel wires
Aluminum and polymer tape protects the cable core from moisture
Excellent solution for wetland and cross-river installation
Aluminum and polymer tape protects optical fiber from hydrogen penetration
Maximum rated design tension up to 17985 lb
Resistance to crushing load up to 571 lb/in
|Maximum rated design tension (MRDT)||1574...17985 lb (7...80 kN)|
|Crush||228 lb/in (0.4 kN/cm)|
|Fiber count, up to||144|
|Operating temperature||-40°F ... +158°F|
|Installation temperature||+14°F ... +122°F|
|Transportation and storage temperature||-40°F ... +158°F|
|Minimum bending radius||15x cable diameter|
Have a question?
Send a request