Applied in the construction of fiber-optic link on overhead transmission lines of 35 kV and more.
Applied for aerial installation on distribution and high voltage power lines, as well as railway catenary.
For fiber optic monitoring systems.
Used for stationary installation when the optical fiber needs extra protection from mechanical damages.
Applied in ducts, trays, blocks, tunnels, collecting channels, with a risk of rodent attacks.
Applied in harsh environments with potential mechanical impact: in all ground types, swamps and harsh rivers.
Rigid yet flexible enough to be installed into microducts.
Applied in sea areas (coastal shelf and deep-sea), on navigable rivers, in lakes and water storage basins, in harsh environments, in bogs and unnavigable rivers.
InAir Figure 8
Applied for aerial installations: on power lines, lamp posts, between buildings and constructions. Suitable for aerial installation on transmission equipment and power facilities in dielectric package.
Applied inside buildings (including vertical runs), in trays, channels, on outer sides of buildings, as well as in duct, in tubes and blocks. Suitable for blowing-in into protecting polyethylene tubes.
Applied for aerial installation on transmission towers, lamp posts, between buildings and constructions.
Steel optical module, clad wire and temporary optical cable.
Designed for short underground pulls requiring low tension. It is highly crush resistant.
Excellent rodent resistance
Maximum rated design tension up to 337 lb
The smallest diameter
|Crush — 400 lb/in|
|Fiber count up to 96|
Get more detail by sending a requestStart shopping
|Operating temperature||-58°F … +32°F|
|Installation temperature||-22°F … +122°F|
|Transportation and storage temperature||-58°F … +32°F|
|Minimum bending radius||15x cable diameter|
|Life time||25 years|
Have a question?
Send a request